(+1) 905 597 5955
Link up to 8 of these 4ft wraparound fixtures on one 5-amp circuit, and run the chain at 347V straight off a Canadian 600V service with no step-down transformer.
Five wattage steps, 50W down to 25W, and five colour temperatures, 3000K to 6000K. Both set on the fixture. Measured output peaks near 5,870 lumens at 4000K.
Stamped metal housing, 0-10V dimming, damp rated, cETL listed, 5 year warranty.
What is a wraparound LED light?
A surface-mounted ceiling fixture with a curved lens that wraps down both sides, so light spills sideways as well as straight down. That's why wraparounds suit corridors and storage aisles better than a flat strip does. Walls and shelf faces get lit, not just the floor. This one runs 47" long, 5.35" wide, and sits 2.17" off the ceiling.
Why spec a 347V wraparound light?
Because 600Y/347V is the standard service in most new mid-size and large Canadian commercial buildings, and a 347V circuit carries far more fixtures per breaker than a 120V one, with no step-down transformer in the middle. Every competing wraparound on page one of Google Canada runs 120V or 120-277V. This one takes anything from 120V to 347V on the same part number.
Sensor version, or this one?
Pick this one when the space already has switching, or when a linked row should come on as a whole. In the sensor version every fixture carries its own occupancy sensor, so an eight-fixture run switches in pieces as somebody walks the aisle. Wire this version to one wall sensor or a relay and the whole chain follows a single command.
What the spec panel leaves out
The manual requires mounting to an electrical outlet box that's supported by building structure, so drywall anchors alone won't pass inspection. Anchor spacing on the 4ft body is 1030mm (40.55"). Bond the ground wire at every fourth fixture in a linked chain. Operating range is -20C to 50C, which rules out an unheated Prairie garage in January. Damp location and IP20 together mean no washdown areas. Connecting cables come in 1ft, 3ft and 6ft and are ordered separately, so measure your spacing before the order goes in.
For the wiring diagram, anchor spacing and the bilingual install steps, open the Manual (PDF), and pull the IES set if your designer needs measured 50W photometry at all five colour temperatures on both 120V and 347V. Send us your fixture count and the service voltage at the panel and we'll come back with a wholesale quote plus a linking layout.
